Skip to content

Rotor overhaul and refurbishment

Together with specialist partners, we repair and refurbish turbomachinery rotors.

Measurements and non-destructive testing tell us which components can be refurbished and which must be replaced, and the rotor is balanced after the repair.

Scope

What the service covers

Every rotor is assessed individually: the repair scope depends on the type and extent of wear, the material and the operating requirements.

  • Dimensional and runout measurements
  • Non-destructive testing (NDT)
  • Refurbishment of journals, seals and surfaces
  • Replacement of blades and rotor components
  • Machining
  • Balancing and final report

When to call us

Typical situations

  • Journal wear

    Wear on bearing and sealing surfaces.

  • Blade erosion

    Material loss on flow-path components.

  • Rotor runout

    Distortion or excessive runout found.

  • Cracks

    Indications from non-destructive testing.

  • Scheduled overhaul

    Rotor removed during a machine overhaul.

  • No spare rotor

    Refurbishment as an alternative to a new rotor.

Recognise one of these symptoms? An analyst will help find the cause.

Outcome

What you get

  • Rotor assessment

    Measurement and test results before the repair.

  • A refurbished rotor

    Components repaired or replaced, machining done.

  • Balancing

    The rotor balanced once the work is complete.

  • Documentation

    Measurement, testing and balancing records.

Process

How we work together

  1. 01

    Request

    Machine type, rotor data, description of wear.

  2. 02

    Assessment

    Dimensional measurements and NDT.

  3. 03

    Repair scope

    Deciding what to refurbish or replace.

  4. 04

    Repair

    Refurbishment, machining, part replacement.

  5. 05

    Balancing and acceptance

    Balancing, final measurements, documentation.

Frequently asked questions

Didn't find your answer? Ask an engineer →

Does a refurbished rotor need to be rebalanced?

Dynamic balancing is usually an important stage of rotor refurbishment, particularly when the repair changes the rotor's mass or geometry. The method and requirements are chosen to suit the design, operating speed and operating conditions. If balancing is part of the order, we document the result in a report.

How is a rotor's condition assessed before refurbishment?

Assessing a rotor before refurbishment includes visual inspection, geometry measurements and identifying areas of wear, cracking or distortion. Depending on the design, non-destructive testing and runout measurements are used, along with analysis of the machine's operating history. On this basis, the possible scope of repairs and subsequent checks, including balancing, is determined. The final decision requires an assessment of the material and operating requirements.

When is refurbishing a rotor a better option than making a new one?

Rotor refurbishment can be the better option when the damage is repairable, the structural integrity is intact, and the time or cost of making a new part is high. However, a repair is not always technically justified, particularly with extensive cracking or where the condition of the material is unknown. A comparison of the options should take into account testing, the scope of machining, balancing and the expected conditions of further operation.

What if a rotor component can't be bought?

Components no longer available on the market can be reproduced through reverse engineering, based on measurements and tests of the original.

Need a diagnosis or a quote?

Basic machine data and a short description are enough.