Skip to content

Hydro units

Monitoring, protection and diagnostics for hydro units — shaft and structural vibration, shaft position and air gap.

Symptoms

Typical problems

  • Load-dependent vibration

    Changes across operating points and flow conditions.

  • Shaft runout and position

    Changes in the guide bearings.

  • Air gap

    Asymmetry and deformation of the stator or rotor.

  • Cavitation

    Erosion and vibration in the turbine water passage.

  • Ageing protection systems

    No support and no spare parts.

Industries

Hydropower · 2025–2026

Protection system retrofit on a hydro unit

TAURON

  • Machinery protection systems
  • Prefabrication, FAT, SAT and commissioning
Read case study

Related projects

  • 2026

    TAURON, Otmuchów hydropower plant · Poland

    Independent vibration measurements on a hydro unit before its overhaul, as reference data for the overhaul.

  • 2025

    Bhotekoshi Power Company · Nepal

    Vibration data of a 22.5 MW turbine-generator analysed: condition, recommendations and expected remaining service life.

Frequently asked questions

Didn't find your answer? Ask an engineer →

Can hydro unit monitoring be connected to the hydropower plant's control system?

Yes. A hydro unit vibration monitoring system can pass measured values, alarms and statuses to the hydropower plant's control system, provided suitable interfaces are available. Integration makes it possible to set diagnostic data against load and hydraulic parameters. We match the scope of communication to the existing control system and the operating requirements.

Which parameters should hydro unit monitoring cover?

Hydro unit monitoring can cover shaft vibration and displacement, bearing vibration, axial position, temperatures and rotational speed. For more complete diagnostics, hydraulic parameters and generator load are also useful. The choice of measurements depends on the design of the hydro turbine, the bearing arrangement and the main operational risks.

Why are hydro units diagnosed at different loads?

Hydro unit vibration can change significantly with turbine load, flow and hydraulic conditions. Measurements taken at only one operating point therefore do not always give the full picture of the unit's condition. Trend analysis, measurements at different loads and, where necessary, during run-up or coast-down help interpret the results correctly.

What are the most common causes of vibration in hydro units?

Vibration in hydro units can result from unbalance, misalignment, bearing problems and hydraulic effects, such as unstable flow and pressure pulsations. The character of the vibration often changes with turbine load. Diagnostics compares shaft and bearing measurements with hydraulic parameters and the generator's operating state. Identifying the cause requires analysis of the hydro unit as a whole.

How can the influence of hydraulic phenomena on hydro turbine vibration be recognised?

Hydraulic effects may be indicated by vibration changes that depend on load, flow, head and turbine operating conditions. Diagnostics includes spectrum analysis and comparison of the vibration with pressure pulsations and other available process data. Measurements at different operating points are particularly important. A high vibration level on its own does not make it possible to distinguish hydraulic from mechanical causes.

How are hydro unit bearing problems diagnosed?

Diagnosing hydro unit bearings depends on their design and on the measurement system. Housing and shaft vibration, temperatures, axial position and, where available, lubrication parameters are analysed. It is important to compare results at different loads and with historical measurements. In fluid-film bearings, orbits and shaft displacement provide additional information. Conclusions should take into account whether the rotor system is vertical or horizontal.

Need a diagnosis or a quote?

Basic machine data and a short description are enough.