Skip to content

Electric motor monitoring

We assess the condition of electric motors and the machines they drive by analysing supply currents and voltages.

Measurements are taken in the switchgear, with no sensors fitted on the machine itself, which makes it easier to supervise hard-to-reach drives.

Scope

What the service covers

Electrical parameter analysis detects electrical faults as well as some mechanical faults in the motor and the driven machine.

  • Current and voltage measurements in the switchgear
  • Assessment of windings and power supply
  • Detection of mechanical faults in the drive
  • Continuous monitoring or periodic measurements
  • Trends and alarms for supervised drives
  • Report with condition assessment and recommendations

When to call us

Typical situations

  • Hard-to-reach drives

    Submersible motors, motors in hazardous areas or mounted high up.

  • Many drives

    A large number of motors without continuous condition supervision.

  • Winding failures

    Recurring electrical failures of motors.

  • Supply problems

    Voltage unbalance, load fluctuations.

  • Adding to vibration data

    Extra information alongside vibration measurements.

  • Overhaul planning

    Choosing which motors need inspection first.

Recognise one of these symptoms? An analyst will help find the cause.

Outcome

What you get

  • Drive condition

    Information on the condition of the motor and the driven machine.

  • Faults identified

    The type of abnormalities found and where they are.

  • Trends

    Changes in condition over time with continuous monitoring.

  • Recommendations

    Recommended actions and how urgent they are.

Process

How we work together

  1. 01

    Request

    Drive list, motor data, access to the switchgear.

  2. 02

    Concept

    Periodic measurements or continuous monitoring.

  3. 03

    Measurement or installation

    Switchgear measurements or device installation.

  4. 04

    Analysis

    Electrical and mechanical condition assessment.

  5. 05

    Report

    Findings, recommendations, further supervision.

  • 2025

    Volkswagen Poznań – Września plant · Poland

    Vibration measurements on 28 electric motors with a diagnostic report and recommended repairs or operating changes.

  • 2024

    Food & beverage plant, Poland

    Vibration monitoring installed on the generator of an engine-driven generating set to assess its dynamic condition.

  • 2017

    Veolia Energia Poznań – Karolin CHP · Poland

    Vibration monitoring of turbogenerator TG1 extended with end-winding vibration measurements.

Frequently asked questions

Didn't find your answer? Ask an engineer →

Does motor monitoring require sensors on the machine?

No. Currents and voltages are measured in the switchgear supplying the motor, which makes it easier to supervise hard-to-reach drives.

Does electrical analysis replace vibration measurements?

The two methods complement each other. Electrical analysis is good at detecting winding and supply faults, while vibration measurements give a detailed picture of the machine's mechanical condition. We choose the method to suit the drive and the purpose of supervision.

Does it work for motors fed from a frequency converter?

That depends on the drive configuration and the chosen solution. We check whether measurement is possible for the specific installation.

Need a diagnosis or a quote?

Basic machine data and a short description are enough.