Skip to content

Pump overhauls

Together with specialist partners, we overhaul industrial pumps.

We start with diagnostics and inspection, then refurbish or replace worn parts, reassemble the pump and check how it runs after the overhaul.

Scope

What the service covers

Diagnostics before the overhaul separate faults in the pump itself from problems caused by operating conditions, alignment or the system layout.

  • Vibration diagnostics before the overhaul
  • Disassembly and component inspection
  • Refurbishment or replacement of impellers, shafts and sleeves
  • Bearing and seal replacement
  • Assembly, alignment and balancing
  • Measurements after start-up

When to call us

Typical situations

  • Rising vibration

    Increasing pump vibration or noise.

  • Lower performance

    Reduced flow or head.

  • Leaks

    Seal wear and leakage.

  • Bearing failures

    Recurring bearing damage.

  • Cavitation and erosion

    Signs of wear on the impeller and casing.

  • Scheduled inspection

    An overhaul during a plant outage.

Recognise one of these symptoms? An analyst will help find the cause.

Outcome

What you get

  • Root cause identified

    A diagnosis before deciding on the scope of work.

  • An overhauled pump

    Parts refurbished or replaced, pump reassembled.

  • Post-overhaul measurements

    Condition confirmed after start-up.

  • Documentation

    Scope of work, records, recommendations.

Process

How we work together

  1. 01

    Request

    Pump type, symptoms, operating conditions.

  2. 02

    Diagnostics

    Measurements and assessment of the cause.

  3. 03

    Inspection

    Disassembly, condition of the parts.

  4. 04

    Overhaul

    Refurbishment or replacement of parts, assembly.

  5. 05

    Acceptance

    Start-up, measurements, documentation.

Frequently asked questions

Didn't find your answer? Ask an engineer →

Why diagnostics before the overhaul?

High pump vibration can come from misalignment, operating conditions or the system layout rather than a fault in the pump itself. Diagnostics help avoid an overhaul that would not remove the cause.

Can the overhaul be done on site?

That depends on the pump type and the scope of work. Some work is done on site and some in a partner's workshop.

Do you supply pump parts?

Yes. We supply standard and made-to-order parts, including parts reproduced through reverse engineering.

Need a diagnosis or a quote?

Basic machine data and a short description are enough.