Skip to content

Wireless and remote monitoring

We implement monitoring for machines where a wired online system is not justified or hard to install.

This applies to auxiliary, distributed and hard-to-reach machinery. Wireless sensors regularly transmit vibration and temperature data, so changes in condition show up without measurement rounds.

Scope

What the service covers

We start by choosing the machines and measurement points, and finish with configured alarms and data available to its users.

  • Selection of machines and measurement points
  • Selection of sensors and communication infrastructure
  • Sensor installation and start of data transmission
  • Configuration of alarm limits and trends
  • Making the data available in the user's system
  • Support in interpreting the results

When to call us

Typical situations

  • Many auxiliary machines

    Pumps, fans and motors without continuous supervision.

  • Difficult access

    Machines in areas where rounds are hard to carry out.

  • Distributed sites

    Equipment at many locations, far from the control room.

  • Measurement rounds

    Periodic measurements take time and miss changes in between.

  • Cabling cost

    A wired system would be out of proportion to the machines' importance.

  • Unplanned failures

    Auxiliary machine failures stop the process.

Recognise one of these symptoms? An analyst will help find the cause.

Outcome

What you get

  • Continuous visibility

    Vibration and temperature trends for the supervised machines.

  • Alarms

    Notifications when limits are exceeded or unusual changes occur.

  • Fewer rounds

    Periodic measurements only where they are really needed.

  • A basis for planning

    Data for planning inspections and repairs.

Process

How we work together

  1. 01

    Request

    Machine list, locations, available infrastructure.

  2. 02

    Concept

    Measurement points, sensors, data transmission.

  3. 03

    Installation

    Fitting sensors and communication gateways.

  4. 04

    Configuration

    Limits, alarms, data access.

  5. 05

    Support

    Help in assessing trends and alarms.

Frequently asked questions

Didn't find your answer? Ask an engineer →

Which machines is wireless monitoring suitable for?

Mostly auxiliary and distributed machinery: pumps, fans, motors, gearboxes. Critical machines with fluid-film bearings usually need a wired protection and online monitoring system.

Does wireless monitoring replace diagnostics?

No. Monitoring flags changes in condition. When a trend or alarm points to a problem, the cause is found through vibration diagnostics, often with additional measurements.

Can the data go to our own system?

How the data is made available is agreed at the concept stage, depending on the chosen solution and the site infrastructure.

Need a diagnosis or a quote?

Basic machine data and a short description are enough.