Skip to content

Integration with control systems

We connect machinery monitoring and protection systems to the site's control and supervisory systems.

Operators see machine measurements, statuses and alarms where they run the process, and the data reaches historian and analytics systems.

Scope

What the service covers

We carry out integration together with the site's automation team or the control system contractor, based on an agreed signal list.

  • Agreeing the signal list and data exchange method
  • OPC and Modbus communication setup
  • Hardwired signals: analogue and relay outputs
  • Mapping of measurements, statuses and alarms
  • Communication tests and value verification
  • Interface documentation

When to call us

Typical situations

  • Data only available locally

    Machine data visible only in the cabinet or MMS software.

  • New control system

    A DCS migration requires reconnecting the MMS.

  • MMS upgrade

    A new monitoring system must be connected to the existing DCS.

  • Inconsistent values

    Differences between MMS and control system readings.

  • Need for history

    Machine data should go to the historian.

  • No documentation

    Unknown or outdated signal list.

Recognise one of these symptoms? An analyst will help find the cause.

Outcome

What you get

  • Working communication

    Measurements, statuses and alarms available in the control system.

  • Verified values

    MMS and control system readings that match.

  • Signal list

    An up-to-date description of all the data exchanged.

  • Interface documentation

    The basis for further maintenance and changes.

Process

How we work together

  1. 01

    Request

    Systems to connect, expected data scope.

  2. 02

    Agreement

    Signal list, protocol, split of tasks.

  3. 03

    Configuration

    Communication setup on the MMS side.

  4. 04

    Testing

    Checking transmission and values with the automation team.

  5. 05

    Documentation

    Interface description and signal list.

Power generation · 2025–2026

3500 system upgrade on a gas turbine

Budapesti Erőmű, Budapest

  • Support for Bently Nevada systems
  • Vibration sensors and measurement chains
  • DCS / SCADA / OPC / Modbus integration
Read case study

Related projects

  • 2025

    ORLEN Unipetrol RPA, Litvínov · Czech Republic

    Service of 3500 and Trendmaster: new channels, alarms, relay logic and Modbus to the DCS and ESD configured; loop checks.

  • 2019

    ANWIL, Włocławek · Poland

    Compressors C1601 and PC112 integrated into the diagnostic system.

  • 2017

    ORLEN Lietuva, Mažeikiai refinery · Lithuania

    3500 monitoring for compressors IK-301 and IK-201: supply, installation, commissioning and System 1 integration.

Frequently asked questions

Didn't find your answer? Ask an engineer →

What data can be sent to the control system?

Usually measurement values, alarm and trip states, and the status of measurement chains and modules. The scope is set when the signal list is agreed.

Are trip functions sent over digital communication?

Machine trip signals are usually hardwired, through relay outputs. Digital communication is mainly used for measurements, statuses and alarms.

Who configures the control system side?

Usually the site's automation team or the DCS contractor. We agree the signal list with them and run the tests together.

Need a diagnosis or a quote?

Basic machine data and a short description are enough.